DirectVent Pro

<p>Concentric Flex offers a cost-effective solution for navigating around obstacles like studs, joists, or trusses, allowing precise vent placement. It speeds up installation and reduces the...

Use to support vent pipe. Provides a 1” clearance.  It's recommend to install Wall Straps at 4-foot intervals on vertical runs.

This Wall Thimble for DirectVent Pro provides a complete wall-pass-through and firestop, when used with the Square Horizontal Cap. When installing, refer to the appliance manufacturer’s...

Use to offset obstructions as needed. Fully unitized, twist-lock construction. Elbows allow the lock to remain fully engaged while aligning to the desired direction. The angle will remain fixed at...

Use for vertical terminations only. Provides improved performance in high wind conditions. Available in aluminum.

Use for supporting vent pipe between offsets.

Use to support vent pipe. Provides a 1” clearance.  It's recommend to install Wall Straps at 4-foot intervals on vertical runs.

Use for standard and high-wind through-the-wall termination. Check installation instructions for restrictions on horizontal cap terminations, such as minimum distance from windows and doors...

Use this cap to terminate a DirectVent Pro installation. Use for vertical terminations only. Check the appliance manufacturer’s instructions to determine which caps are approved for use with...

Kit includes: 90° black Elbow, Ceiling Support/Wall Thimble Cover, 24” black Pipe, and 8 1⁄2” black Pipe Extension. Termination cap not included. For 4” x 6...

Required for multi-story vertical installations at the second floor and any subsequent floors.

Use to maintain a weather tight resistant seal between the pipe and the flashing.

Use to pass through ceiling and support pipe. May be used on vaulted or flat ceilings. Painted black. Trim and clamp included.

Use as a decorative cover for horizontal (through-wall) installations or for flat ceiling installations. Fits over the Wall Thimble face plate. Comes with an insulation ring to reduce air...

Use when installing a direct vent co-linear insert into a masonry chimney.Kit includes: Prairie Termination Cap; and two pieces of Aluminum Flex lengths - one Red (exhaust), and one Green (air...

Use when installing a direct vent, co-linear insert into a masonry chimney. Kit includes: High-Wind Termination; and two pieces of Aluminum Flex lengths - one Red (exhaust), and one Green (air...

Use when installing a direct vent co-linear insert into a masonry chimney.Kit includes: Prairie Termination Cap; and two pieces of Aluminum Flex lengths - one Red (exhaust), and one Green (air...

Use for vertical terminations only. Provides improved performance in high wind conditions. For vertical terminations only. Available in aluminum.