Ventinox

The Adjustable Oval Insert Boot is made with 11 gauge, carbon steel. It is used to connect inserts with rectangular flue outlets up to 6" x 16 ½" with oval flex connectors. The two-piece...

Use as a straight or up to 90° connection between liner and appliance flue collar.

These Oval Tees are made with 316 stainless steel, and allow for easy, secure liner installation by using pop rivets. The round take-off is 2" long, crimped, and welded for added strength. This Oval...

Use to increase reach through masonry at wall thimble.

Introducing the Ventinox/DuraFlex Tee with Removable Take-Off, engineered for optimal chimney performance. Crafted from VG AL29-4C Stainless Steel, this tee offers unparalleled strength and...

These Ventinox/DuraFlex Tees can be used to transition between liner and connector pipe at the wall thimble, or the rear flue outlet of an appliance. Featuring a 8" long, removable tee snout designed...

Ventinox/DuraFlex Sleeves are made of AL29-4C Stainless Steel and is used to connect a liner into am appliance flue collar.

Use this Sleeve, made with 316 titanium stainless steel, to join Ventinox Liner to an appliance flue collar. Just slide the liner into the flared end and tighten the locking band to hold it secure...

Ventinox/Duraflex Round to Oval Adapters are made of 316 Stainless Steel and connect to an oval appliance flue collar.

Use these Installation Cones when pulling Ventinox Liner down and around bends. It features holes in the top for a knotted rope to pass through.

Bird Screens fit into the cap, securing itself with tabs. The screen openings measure 1 ½" diagonally.Sizes correspond to Rain Cap diameter.For use with Ventinox/Duraflex Rain Caps

Ventionx/Duraflex Rain Caps are used to support a liner from the top and form a seal between the Storm Collar and the Top Plate. The top is removable for easy access to chimney cleaning. The rain...

The Storm Collar for Ventinox Liner tightens to the liner with a locking band, and fits over the raised lip on the top plate. When installing, run a bead of silicone around the base for added water...

Top Plates are designed to fit on the top of the flue or chimney, and prevent rainwater from entering the flue with their raised lip construction. Make sure to use high-temperature, silicone sealant...

Ventinox/Duraflex Base Plates are similar to the top cover plate and are used to block off Thermix insulation at the bottom.

Ventinox/DuraFlex Bottom PlateAttach to bottom of liner in the smoke chamber of a fire place, then pull up to form a seal between the liner and clay tile.

Use as connector between liner and Tee. Allows tee body to be rotated at wall thimble.